Thermal evolution of single phase lanthanum zirconate

M. O.D. Jarligo, Y. S. Kang, A. Kawasaki

研究成果: Article査読

9 被引用数 (Scopus)

抄録

Lanthania (La2O3) and zirconia (ZrO2) powders in ethanol based suspension were mechanochemically treated in a planetary ball mill for 12 hours at 200 rpm, dried and sintered at various temperatures from 400 °C to 1500°C. Particles in nanometer sizes are produced after milling. X-ray diffractometry results show the formation of single phase lanthanum zirconate on subsequent heat treatment for 1h at 1500°C. Phase evolution based on the intensities of the XRD plots and BET surface area analysis indicates three stages of crystallization: below 800°C, between 800°C and ∼1100°C, and above 1100°C where reflections of La2Zr2O7 with pyrochlore structure are increased with further heating. Only endothermic energy peaks are observed in the differential thermal analysis (DTA) curve of the milled powders, which could be attributed to the reactions involving dehydroxylation, decarboxylation and complete disintegration of ethanol. This indicates that probably, lanthanum zirconate has grown on sintering at high temperatures from the very fine particles produced by mechanochemical activation during milling. Thermogravimetric analysis has recorded a total weight loss of ∼9% from the original weight of the milled powder on sintering at 1500°C. The values of the surface area of the powders are found to decrease while the crystallite size of La2Zr2O7 are increased with increasing temperature.

本文言語English
ページ(範囲)31-36
ページ数6
ジャーナルKey Engineering Materials
317-318
DOI
出版ステータスPublished - 2006

ASJC Scopus subject areas

  • 材料科学(全般)
  • 材料力学
  • 機械工学

フィンガープリント

「Thermal evolution of single phase lanthanum zirconate」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル