The control of oxidation-induced intergranular embrittlement by grain boundary engineering in rapidly solidified Ni-Fe alloy ribbons

Shin Ichi Yamaura, Sadahiro Tsurekawa, Tadao Watanabe

    研究成果: Article査読

    23 被引用数 (Scopus)

    抄録

    The relation between grain boundary microstructure and oxidation-induced intergranular embrittlement has been investigated in rapidly solidified and subsequently annealed Ni-39 mass%Fe thin ribbons with different grain boundary microstructures. These thin ribbons were heated in air under different tensile stresses to enhance intergranular oxidation. Oxidation-induced embrittlement was then evaluated by three-point bending tests. It was found that the brittleness of oxidized ribbons varied according to the grain boundary microstructure. Fine-grained microstructure was found to be superior to coarse-grained one by suppressing oxidation-induced embrittlement when the type and the frequency of grain boundaries (that is called the Grain Boundary Character Distribution, GBCD) were properly controlled. Moreover, for a given grain size, grain boundary microstructure containing higher frequencies of special boundaries was shown to be advantageous in the control of oxidation-induced intergranular embrittlement. On the basis of these findings, the importance and usefulness of grain boundary engineering for the control of oxidation-induced intergranular embrittlement are discussed.

    本文言語English
    ページ(範囲)1494-1502
    ページ数9
    ジャーナルMaterials Transactions
    44
    7
    DOI
    出版ステータスPublished - 2003 7

    ASJC Scopus subject areas

    • Materials Science(all)
    • Condensed Matter Physics
    • Mechanics of Materials
    • Mechanical Engineering

    フィンガープリント 「The control of oxidation-induced intergranular embrittlement by grain boundary engineering in rapidly solidified Ni-Fe alloy ribbons」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル