Strain-induced martensite formation in austenitic stainless steel

Mitsuhiro Okayasu, Hironobu Fukui, Hiroaki Ohfuji, Tetsuro Shiraishi

研究成果: Article査読

24 被引用数 (Scopus)

抄録

In situ measurements of the strain-induced martensitic transformation (SMTs) of SUS304 stainless steel that takes place during tensile loading at room temperature were performed around the notch of a dumbbell-shaped specimen where high stress concentration occurs. Even in the low plastic strain regime, with loading to 0.2 % proof stress (σ 0.2), some SMTs occurred. However, the area fraction of the Fe-α′-martensite phase did not increase significantly even when the sample was loaded to the ultimate tensile strength (σ UTS). After the σ UTS point, the total fraction of the Fe-α′ phase increased dramatically to the fracture point (σ f). The phase textures of Fe-α′ and Fe-γ were almost equal at (σ UTS - σ f)/2, and the Fe-α′ phase was observed over almost the entire measurement area around the notch at the σ f point. However, the area fraction of the Fe-α′ phase at the σ f point decreased far away from the fracture surface, to an extent that the total fraction of the Fe-α′ phase was almost the same as that of the Fe-γ phase in an area about 1.7 mm from the fracture face. Different martensite characteristics were detected in the stainless steel, depending on the applied load level. This was attributed to the severity of deformation. In particular, deformation twinning, created around σ UTS, and severe plastic deformation before fracture make a strong Fe-α′ phase. Details of this phenomenon are interpreted using various approaches, including electron backscatter diffraction analysis and finite element analysis.

本文言語English
ページ(範囲)6157-6166
ページ数10
ジャーナルJournal of Materials Science
48
18
DOI
出版ステータスPublished - 2013 9月
外部発表はい

ASJC Scopus subject areas

  • 材料科学(全般)
  • 材料力学
  • 機械工学

フィンガープリント

「Strain-induced martensite formation in austenitic stainless steel」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル