Recovery time analysis in a tri-axial HTS cable after an over-current fault

N. Hu, M. Toda, T. Watanabe, M. Tsuda, T. Hamajima

研究成果: Article査読

7 被引用数 (Scopus)

抄録

A tri-axial HTS cable with the advantage of compact structure, low heat loss, and low cost is a perfect solution for future distribution power network demand. In our previous research, a typical single line to ground (SLG) fault simulation was carried out in an adiabatic condition. A stabilizer layer thickness design of the tri-axial HTS cable based on a calculation of maximum temperature rise in the worst condition was proposed. However, in practical application, after the quenched cable is removed from the network by a breaker, a recovery time is also a very important parameter to decide if the cable is allowed to reconnect to the power network. In this paper, a one-dimensional computational fluid dynamics (CFD) analysis is carried out to simulate the transient thermal behavior of the cable. The result shows that it takes time to recover the cable temperature to the steady-state operation level due to a low thermal conductivity of the insulation layer. Since the cable is cooled by forced liquid nitrogen (LN2) flow, there is a temperature gradient along the cable. The temperature of LN2 gradually rises after the fault until the warmed coolant runs out of the cable.

本文言語English
ページ(範囲)1295-1299
ページ数5
ジャーナルPhysica C: Superconductivity and its applications
471
21-22
DOI
出版ステータスPublished - 2011 11

ASJC Scopus subject areas

  • Electronic, Optical and Magnetic Materials
  • Condensed Matter Physics
  • Energy Engineering and Power Technology
  • Electrical and Electronic Engineering

フィンガープリント 「Recovery time analysis in a tri-axial HTS cable after an over-current fault」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル