Reaction of Si surfaces with a C2H4 beam

I. Kusunoki, T. Takagaki, S. Ishidzuka, Y. Igari, Tsuyoshi Takaoka

研究成果: Article

42 引用 (Scopus)

抜粋

The reactions of Si(100) and (111) surfaces with a C2H4 beam in ultrahigh vacuum were studied using high resolution X-ray photoelectron spectroscopy (XPS) at temperatures of 600-900°C. These reactions produce silicon carbide (SiC) layers on the silicon surfaces, the growth rates of which increase with surface temperature up to about 675°C, but decrease at higher temperatures. The observed behavior is explained by the balance between the carbon supply rate from the C2H4 beam and the silicon out-diffusion rate from the substrate to the carbide surface. The carbon supply rate is limited by the surface residence time of chemisorbed C2H4 and the beam flux. At the temperature of maximal growth the composition ratio of carbon to silicon in the carbide layer is close to unity, but decreases with increasing temperature. Below the optimal temperature the FWHM of the C 1s XPS peak is broader than that of the stoichiometric compound SiC, implying that the chemical bonding in the carbide layer is distributed. The SiC bulk plasmon-loss peaks accompanying the Si 2s and C 1s XPS peaks appear in carbide films thicker than about 13 Å.

元の言語English
ページ(範囲)131-144
ページ数14
ジャーナルSurface Science
380
発行部数1
DOI
出版物ステータスPublished - 1997 5 1

ASJC Scopus subject areas

  • Condensed Matter Physics
  • Surfaces and Interfaces
  • Surfaces, Coatings and Films
  • Materials Chemistry

フィンガープリント Reaction of Si surfaces with a C<sub>2</sub>H<sub>4</sub> beam' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用

    Kusunoki, I., Takagaki, T., Ishidzuka, S., Igari, Y., & Takaoka, T. (1997). Reaction of Si surfaces with a C2H4 beam. Surface Science, 380(1), 131-144. https://doi.org/10.1016/S0039-6028(97)00007-1