Radiation damages and bubble formation of ion implanted furan-resin-derived carbon

Yoshikazu Teranishi, Tomohiro Kobayashi, Eiichi Yasuda, Masaya Iwaki, Masato Kakihana, Manabu Fukushima, Kazumasa Nakamura, Yasuhiro Tanabe

研究成果: Article査読

2 被引用数 (Scopus)

抄録

Furan-resin-derived carbon generally produces a glass-like carbon (GC) having entangled graphene layers after high temperature heat treatments. However, furan-resin-derived carbon produced well-graphitized thin skin on surfaces after heat-treatment at 3000 °C. Since ion implantation is a useful technique for surface modification, we used them to investigate the mechanism of well-graphitized thin skin on surfaces of furan-resin-derived carbon after heat-treatment at 3000 °C. In this investigation, we observed morphological changes on Ar+ or Xe+ implanted GC surfaces using SEM&TEM and Raman spectroscopy. Ar or Xe ions were implanted into the furan-resin-derived carbon heat-treated at 3000 °C at energy of 60-160 keV at a fluence ranging from 1×1015 to 1×1017 ions/cm2. Microstructural changes were examined by Raman spectroscopy. The implanted surfaces of the specimens were changed to an amorphous structure by the ion implantation. Moreover, morphological SEM&TEM observations revealed that clear bubbles with diameter of 10-80 nm were present in the Ar+-implanted specimen at a fluence of 1×1017 ions/cm2. However, bubbles did not appear in the Ar+-implanted specimen at a fluence of 1×1016 ions/cm2. On the other hand, bubbles with diameter of 15-30 nm were present in the Xe+-implanted specimens at a fluence of 1×1016 ions/cm2. The Xe+-implanted specimens were subjected to annealing of re-heat-treatment at 3000 °C. After the annealing, the bubbles were lost in the interior of specimens by cross-sectional SEM observations. Moreover, on the implanted surfaces appeared big bubbles, which were not presented on the implanted surface before annealing. The sizes of these big bubbles were about 2-10 μm. Using Raman spectroscopy, we observed that on the surface of the big bubbles the structure was re-well-graphitized. On the surface of non-bubbled areas it was less graphitized. Thus annealing provided a restoration of the structural, but much effective only on the bubble surfaces.

本文言語English
ページ(範囲)216-220
ページ数5
ジャーナルSurface and Coatings Technology
196
1-3 SPEC. ISS.
DOI
出版ステータスPublished - 2005 6 22
外部発表はい

ASJC Scopus subject areas

  • 化学 (全般)
  • 凝縮系物理学
  • 表面および界面
  • 表面、皮膜および薄膜
  • 材料化学

フィンガープリント

「Radiation damages and bubble formation of ion implanted furan-resin-derived carbon」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル