Profile error compensation approaches for parallel nanogrinding of aspherical mould inserts

H. Huang, W. K. Chen, T. Kuriyagawa

研究成果: Article査読

64 被引用数 (Scopus)

抄録

This paper reports a parallel nanogrinding protocol for fabricating aspherical mould inserts. In the protocol, a preliminary grinding cycle was first employed, which significantly reduced the effect of the initial wheel geometry error on the ground profile accuracy. A new compensation approach was developed. The compensation used the ground profile measured from a Talysurf profilometer to modify the NC tool path for the next grinding cycle. The tool path was modified by offsetting the residual profile error along the normal direction of a grinding point, rather than in the horizontal direction commonly used in the conventional method. The performance of the developed method was evaluated by fabricating aspherical mould inserts on cemented tungsten carbide. The result indicated that the residual profile error after two grinding cycles was reduced to approximately 0.4 μm in PV, with average surface roughness of below 10 nm, which is more efficient than the conventional compensation process.

本文言語English
ページ(範囲)2237-2245
ページ数9
ジャーナルInternational Journal of Machine Tools and Manufacture
47
15
DOI
出版ステータスPublished - 2007 12 1

ASJC Scopus subject areas

  • Mechanical Engineering
  • Industrial and Manufacturing Engineering

フィンガープリント 「Profile error compensation approaches for parallel nanogrinding of aspherical mould inserts」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル