Production of thick sheets of an amorphous Fe77 P13C10 alloy by incremental solidification method

Akihisa Inoue, Yuichi Tachiya, Junji Saida, Tsuyoshi Masumoto

研究成果: Article査読

6 被引用数 (Scopus)

抄録

By using a new combined technique consisting of high-pressure gas atomization, followed by melt spinning, it has been found that an amorphous alloy sheet with a thickness as large as about 0.6 mm can be produced for an Fe77P13C10 alloy. Crystallization and glass transition behaviors remain unchanged for the amorphous sheets with thicknesses ranging from 0.1 to 0.6 mm. Neither contrast revealing the interface among atomized droplets nor the precipitation of crystalline phase is seen in the sheets below about 0.6 mm thickness and the bending fracture surface consists only of a vein-like pattern. The thick amorphous alloy sheets are interpreted to result from spinning-induced incremental solidification of atomized liquid droplets supercooled up to temperatures just above Tg.

本文言語English
ページ(範囲)118-127
ページ数10
ジャーナルScience Reports of the Research Institutes, Tohoku University, Series A: Physics, Chemistry and Metallurgy
34
1
出版ステータスPublished - 1988 3月 1

ASJC Scopus subject areas

  • 凝縮系物理学
  • 金属および合金

フィンガープリント

「Production of thick sheets of an amorphous Fe77 P13C10 alloy by incremental solidification method」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル