Orbital evolution and accretion of protoplanets tidally interacting with a gas disk. II. Solid surface density evolution with type-I migration

Junko K. Daisaka, Hidekazu Tanaka, Shigeru Ida

研究成果: Article査読

20 被引用数 (Scopus)

抄録

This paper investigates the surface density evolution of a planetesimal disk due to the effect of type-I migration by carrying out N-body simulation and through analytical method, focusing on terrestrial planet formation. The coagulation and the growth of the planetesimals take place in the abundant gas disk except for a final stage. A protoplanet excites density waves in the gas disk, which causes the torque on the protoplanet. The torque imbalance makes the protoplanet suffer radial migration, which is known as type-I migration. Type-I migration time scale derived by the linear theory may be too short for the terrestrial planets to survive, which is one of the major problems in the planet formation scenario. Although the linear theory assumes a protoplanet being in a gas disk alone, Kominami et al. [Kominami, J., Tanaka, H., Ida, S., 2005. Icarus 167, 231-243] showed that the effect of the interaction with the planetesimal disk and the neighboring protoplanets on type-I migration is negligible. The migration becomes pronounced before the planet's mass reaches the isolation mass, and decreases the solid component in the disk. Runaway protoplanets form again in the planetesimal disk with decreased surface density. In this paper, we present the analytical formulas that describe the evolution of the solid surface density of the disk as a function of gas-to-dust ratio, gas depletion time scale and semimajor axis, which agree well with our results of N-body simulations. In general, significant depletion of solid material is likely to take place in inner regions of disks. This might be responsible for the fact that there is no planet inside Mercury's orbit in our Solar System. Our most important result is that the final surface density of solid components (Σd) and mass of surviving planets depend on gas surface density (Σg) and its depletion time scale (τdep) but not on initial Σd; they decrease with increase in Σg and τdep. For a fixed gas-to-dust ratio and τdep, larger initial Σd results in smaller final Σd and smaller surviving planets, because of larger Σg. To retain a specific amount of Σd, the efficient disk condition is not an initially large Σd but the initial Σd as small as the specified final one and a smaller gas-to-dust ratio. To retain Σd comparable to that of the minimum mass solar nebula (MMSN), a disk must have the same Σd and a gas-to-dust ratio that is smaller than that of MMSN by a factor of 1.3 × (τdep / 1   Myr) at ∼1 AU. (Equivalently, type-I migration speed is slower than that predicted by the linear theory by the same factor.) The surviving planets are Mars-sized ones in this case; in order to form Earth-sized planets, their eccentricities must be pumped up to start orbit crossing and coagulation among them. At ∼5 AU, Σd of MMSN is retained under the same condition, but to form a core massive enough to start runaway gas accretion, a gas-to-dust ratio must be smaller than that of MMSN by a factor of 3 × τdep / 1   Myr.

本文言語English
ページ(範囲)492-507
ページ数16
ジャーナルIcarus
185
2
DOI
出版ステータスPublished - 2006 12月
外部発表はい

ASJC Scopus subject areas

  • 天文学と天体物理学
  • 宇宙惑星科学

フィンガープリント

「Orbital evolution and accretion of protoplanets tidally interacting with a gas disk. II. Solid surface density evolution with type-I migration」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル