Morphological design of polymer-dispersed liquid crystal for spatial light modulators

Hideo Fujikake, Kuniharu Takizawa, Hiroshi Kikuchi, Takanori Fujii, Masahiro Kawakita

研究成果: Article査読

抄録

With a view to development of optically addressed spatial light modulators with high resolution for high-brightness projection displays, a morphological design and its fabrication have been carried out for polymer-dispersed liquid crystals. To finely disperse the small and uniform-size liquid crystal droplets, polymer-dispersed liquid crystals were produced with different liquid crystal content, ultraviolet light intensity, and substrate wetness. The polymer morphology of the interior and the interface with the substrate were observed with a scanning electron microscope. Based on the experimental results, transmission-type spatial light modulators were fabricated with polymer-dispersed liquid crystals (10 μm thick) and Bi12SiO20 photoconductor (250 μm thick). By inputting fine optical images, the limiting resolution of the device was measured. The resolution of the spatial light modulator strongly depends on the dispersive structures of the liquid crystal microdroplets and reaches a maximum of 64 line pairs/mm as a result of optimization.

本文言語English
ページ(範囲)64-72
ページ数9
ジャーナルElectronics and Communications in Japan, Part II: Electronics (English translation of Denshi Tsushin Gakkai Ronbunshi)
81
12
DOI
出版ステータスPublished - 1998 12
外部発表はい

ASJC Scopus subject areas

  • 物理学および天文学(全般)
  • コンピュータ ネットワークおよび通信
  • 電子工学および電気工学

フィンガープリント

「Morphological design of polymer-dispersed liquid crystal for spatial light modulators」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル