Magnetic anisotropy and order structure of L 10-FePt(001) single-crystal films grown epitaxially on (001) planes of MgO, SrTiO 3, and MgAl2O4 substrates

A. Hotta, T. Ono, M. Hatayama, K. Tsumura, N. Kikuchi, S. Okamoto, O. Kitakami, T. Shimatsu

研究成果: Article

20 被引用数 (Scopus)

抄録

L10-FePt(001) single-crystal films were grown epitaxially on SrTiO3(001), MgAl2O4(001), and MgO(001) substrates. Their uniaxial magnetic anisotropy Ku and the order structure were examined for the film thickness t range of 2-14nm. All series of films show large Ku of 4×107erg/cm3 in the thickness range higher than 10nm, with order parameter S of 0.8 and saturation magnetization Ms of 1120emu/cm3. Ku decreased gradually as t decreased. The Ku reduction was considerable when t decreased from 4nm to 2nm. No marked difference in the thickness dependence of Ku was found in any series of films, although the lattice mismatch between FePt and the substrates was markedly different. K u reduction showed good agreement with the reduction of S for the films on MgAl2O4 and MgO. The Ku ∼S 2 plot showed an almost linear relation, which is in good agreement with theoretical predictions. Transmission electron microscopy images for a FePt film on MgO substrate revealed that the lattice mismatch between FePt(001) and MgO(001) was relaxed in the initial 1 or 2 layers of FePt(001) lattices, which is likely to be true also for two other series of films.

本文言語English
論文番号17B712
ジャーナルJournal of Applied Physics
115
17
DOI
出版ステータスPublished - 2014 5 7

ASJC Scopus subject areas

  • Physics and Astronomy(all)

フィンガープリント 「Magnetic anisotropy and order structure of L 1<sub>0</sub>-FePt(001) single-crystal films grown epitaxially on (001) planes of MgO, SrTiO <sub>3</sub>, and MgAl<sub>2</sub>O<sub>4</sub> substrates」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル