Laser projection CVD using the low temperature condensation method

Kohji Takashima, Kazuyuki Minami, Masayoshi Esashi, Jun ichi Nishizawa

研究成果: Article査読

4 被引用数 (Scopus)

抄録

Laser projection CVD using the low temperature condensation method was developed. By irradiating a cooled substrate with an ArF excimer laser in an organic gas environment, polymethylmethacrylate (PMMA), tin dioxide and silicon dioxide films were deposited selectively with a high deposition rate of about 0.1 μm min-1. Special attention was given to the silicon dioxide film in order to obtain a high deposition rate and good quality. These films can be deposited successively, being promising for the realization of stacked microstructures. This technique can be also applied where a uniform resist coating is not possible. By using this technique, the PMMA film was selectively deposited on the end of an optical fiber.

本文言語English
ページ(範囲)366-374
ページ数9
ジャーナルApplied Surface Science
79-80
C
DOI
出版ステータスPublished - 1994 5 2

ASJC Scopus subject areas

  • Chemistry(all)
  • Condensed Matter Physics
  • Physics and Astronomy(all)
  • Surfaces and Interfaces
  • Surfaces, Coatings and Films

フィンガープリント 「Laser projection CVD using the low temperature condensation method」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル