Laser-beam Scanning Displacement Measurement for Pipe Interior Geometry Mapping

Mamoru Mizunuma, Shigeki Ogawa, Chikara Nishimura, Hiroki Kuwano

研究成果: Article査読

抄録

This paper proposes a displacement measuring technique for detailed noncontact mapping of the interior geometry of pipings. The technique, which is based on the optical triangulation measurement, employs a laser-beam scanner to measure displacement in all radial directions. In order to achieve high precision measurement with this technique, three algorithms that calculate the displacement from sensor output are introduced and experimentally compared. The results clarify two problems: (1) the characteristic curves obtained using the technique are non-linear, (2) the curves differ slightly with respect to measuring direction. An algorithm that calculates the measured displacement by using a characteristic curve in the corresponding direction enables high accuracy measurement. The measurement accuracy of the experimental system is evaluated to be ±0.2 mm in the range of 33-42 mm radius. A pipe interior geometry mapping system utilizing this technique with computer-managed data-taking and graphic display is also described. Its effectiveness is shown by the experimental results.

本文言語English
ページ(範囲)1856-1861
ページ数6
ジャーナルJournal of the Japan Society for Precision Engineering
57
10
DOI
出版ステータスPublished - 1991
外部発表はい

ASJC Scopus subject areas

  • 機械工学

フィンガープリント

「Laser-beam Scanning Displacement Measurement for Pipe Interior Geometry Mapping」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル