Improvement of friction and wear properties of CVD-SiC films with new surface finishing method 'ELID-grinding'

T. Kato, H. Ohmori, C. Zhang, T. Yamazaki, Y. Akune, K. Hokkirigawa

研究成果: Article査読

4 被引用数 (Scopus)

抄録

The purpose of this investigation is to analyze the friction and wear properties of CVD-SiC films finished with ELID-grinding and conventional grinding under dry condition. Normal load is changed from 0.049N to 9.8 N, the following results are obtained: the friction coefficient of CVD-SiC films finished with two kinds of grinding method show similar results; specific wear rate of CVD-SiC films with ELID-grinding does not depend on the grinding direction; wear mode are classified into two types, powder formation (ws≧10-9mm2/N) and without powder formation (ws≦ 3×10-10mm2/N).;CVD-SiC films with ELID-grinding showed high wear resistance because the wear mode of powder formation did not occur when Pmax is less than Pmax.c.; transition between powder formation and non powder formation is explained in terms of the dimensionless parameter Sc* and transition of specific wear rate is explained in terms of the dimensionless parameter Sw*.

本文言語English
ページ(範囲)91-102
ページ数12
ジャーナルKey Engineering Materials
196
出版ステータスPublished - 2001 1 1
外部発表はい

ASJC Scopus subject areas

  • 材料科学(全般)
  • 材料力学
  • 機械工学

フィンガープリント

「Improvement of friction and wear properties of CVD-SiC films with new surface finishing method 'ELID-grinding'」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル