High-efficiency machining of single-crystal germanium using large-radius diamond tools

Tsutomu Ohta, Jiwang Yan, Shuuma Yajima, Youichi Takahashi, Naoyuki Horikawa, Tsunemoto Kuriyagawa

研究成果: Article査読

12 被引用数 (Scopus)

抄録

Round-nosed diamond tools with various nose radii are used for cutting single crystalline germanium and fundamental machining characteristics are examined. It is found that when cutting with small radius tools, the principal cutting force is dominant and crater wear on rake face is significant. However, when cutting with large radius tools, the thrust force becomes significant and tool failure is caused by formation of an angular flank wear land. The use of a large radius tool at a high tool feed improves ductile machining efficiency by a factor of over ten, thus is useful for reducing infrared lens manufacturing costs.

本文言語English
ページ(範囲)374-392
ページ数19
ジャーナルInternational Journal of Surface Science and Engineering
1
4
DOI
出版ステータスPublished - 2007 1 1

ASJC Scopus subject areas

  • Mechanical Engineering
  • Surfaces and Interfaces
  • Surfaces, Coatings and Films

フィンガープリント 「High-efficiency machining of single-crystal germanium using large-radius diamond tools」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル