Heat-transfer and pressure drop characteristics of micro-lattice materials fabricated by selective laser metal melting technology

S. Takarazawa, K. Ushijima, R. Fleischhauer, J. Kato, K. Terada, W. J. Cantwell, M. Kaliske, S. Kagaya, S. Hasumoto

研究成果: Article査読

抄録

This paper describes the findings of a numerical and experimental study on the heat transfer coefficient and pressure drop in micro-lattice blocks fabricated by selective laser metal melting and subjected to forced air convection. In particular, the influence of the unit-cell topology on the thermofluid performance of the lattice structure is examined in detail. In the present numerical study, five lattice block designs (BCC, BCCZ, FCC, FCCZ and F2BCC) are considered for investigation. Regarding effective thermal conductivity, the FCC and FCCZ lattices offer the best performance among the various lattices. In terms of heat transfer capacity per unit mass, the BCC and BCCZ lattices exhibit superior characteristics relative to the other lattices. Also, F2BCC lattice offers the lowest pressure loss for a given relative density. In addition, it is found that the heat transfer coefficients obtained by experiment lie between two numerical results having different strut diameter, which is due to the fact that the equivalent strut diameter in the as-manufactured samples is greater, due to the present of additional metal particles fused onto the surfaces of some struts. Moreover, it is found from our experimental investigation that the heat transfer coefficient h for the BCCZ is approximately 1.3 times higher than that for the BCC lattice for the same pressure loss.

本文言語English
ページ(範囲)125-141
ページ数17
ジャーナルHeat and Mass Transfer/Waerme- und Stoffuebertragung
58
1
DOI
出版ステータスPublished - 2022 1

ASJC Scopus subject areas

  • 凝縮系物理学
  • 流体および伝熱

フィンガープリント

「Heat-transfer and pressure drop characteristics of micro-lattice materials fabricated by selective laser metal melting technology」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル