FATIGUE FRACTURE TOUGHNESS AND FATIGUE CRACK PROPAGATION IN 5. 5% Ni STEEL AT LOW TEMPERATURE.

T. Kawasaki, T. Yokobori, Y. Sawaki, S. Nakanishi, H. Izumi

    研究成果: Paper査読

    4 被引用数 (Scopus)

    抄録

    For design against fatigue, the importance of the fatigue fracture toughness K//f//c has been proposed and a recent experimental investigation revealed that the fatigue fracture toughness for high strength tempered martenisitic steel was only about half of that of usual fracture toughness. This means that K//f//c, not K//l//c, should be taken into consideration against fatigue design since the critical flaw size in fatigue condition predicted from K//f//c would be one quarter comparing with that in static condition. A very sharp toughness transition of K//f//c is observed at about 123 K ( minus 150 degree C) for this steel, namely K//f//c is drastically reduced within a fairly sharp temperature interval and decreases further with decreasing temperature below FTT. The object of the present investigation is to study much more thoroughly the fatigue crack propagation in 5. 5% Ni steel with special interest for its difference between above and below the FTT.

    本文言語English
    ページ857-864
    ページ数8
    DOI
    出版ステータスPublished - 1978
    イベントFract 1977 $—$ adv in res on the strength and fract of mater, Int Conf on Fract, 4th - Waterloo, Ont, USA
    継続期間: 1977 6 191977 6 24

    Other

    OtherFract 1977 $—$ adv in res on the strength and fract of mater, Int Conf on Fract, 4th
    CityWaterloo, Ont, USA
    Period77/6/1977/6/24

    ASJC Scopus subject areas

    • 工学(全般)

    フィンガープリント

    「FATIGUE FRACTURE TOUGHNESS AND FATIGUE CRACK PROPAGATION IN 5. 5% Ni STEEL AT LOW TEMPERATURE.」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル