Fabrication of low-cost beta-type Ti-Mn alloys for biomedical applications by metal injection molding process and their mechanical properties

Pedro Fernandes Santos, Mitsuo Niinomi, Huihong Liu, Ken Cho, Masaaki Nakai, Yoshinori Itoh, Takayuki Narushima, Masahiko Ikeda

研究成果: Article

37 引用 (Scopus)

抜粋

Titanium and its alloys are suitable for biomedical applications owing to their good mechanical properties and biocompatibility. Beta-type Ti-Mn alloys (8-17 mass% Mn) were fabricated by metal injection molding (MIM) as a potential low cost material for use in biomedical applications. The microstructures and mechanical properties of the alloys were evaluated. For up to 13 mass% Mn, the tensile strength (1162-938 MPa) and hardness (308-294 HV) of the MIM fabricated alloys are comparable to those of Ti-Mn alloys fabricated by cold crucible levitation melting. Ti-9Mn exhibits the best balance of ultimate tensile strength (1046 MPa) and elongation (4.7%) among the tested alloys, and has a Young's modulus of 89 GPa. The observed low elongation of the alloys is attributed to the combined effects of high oxygen content, with the presence of interconnected pores and titanium carbides, the formation of which is due to carbon pickup during the debinding process. The elongation and tensile strength of the alloys decrease with increasing Mn content. The Ti-Mn alloys show good compressive properties, with Ti-17Mn showing a compressive 0.2% proof stress of 1034 MPa, and a compressive strain of 50%.

元の言語English
ページ(範囲)497-507
ページ数11
ジャーナルJournal of the Mechanical Behavior of Biomedical Materials
59
DOI
出版物ステータスPublished - 2016 6 1

ASJC Scopus subject areas

  • Biomaterials
  • Biomedical Engineering
  • Mechanics of Materials

フィンガープリント Fabrication of low-cost beta-type Ti-Mn alloys for biomedical applications by metal injection molding process and their mechanical properties' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用