Fabrication of a micropump for integrated chemical analyzing systems

Shuichi Shoji, Masayoshi Esashi

研究成果: Article査読

4 被引用数 (Scopus)

抄録

Utilizing micromachining based on the semiconductor device fabrication technique, a miniature pump (micropump) was fabricated on a silicon substrate. The purpose of this study is to integrate a conventional chemical analyzing system on an Si substrate by using microchemical sensors such as ISFET's and microvalves. The micropump was the diaphragm type. The pump was composed of an inlet and outlet having a one‐way microvalve, a pressure chamber formed on an Si substrate and a miniature piezoactuator. The size of the pump was 8 mm x 10 mm x 10 mm and the flow rate on the order of μl/min could easily be controlled by the voltage signal applied to the actuator. To monitor the flow of the pump, a differential pressure sensor which could be formed on the Si substrate was developed. The sensor was composed of a oneway valve and a piezoresistive diaphragm‐type pressure sensor, and had a high sensitivity to small flow.

本文言語English
ページ(範囲)52-59
ページ数8
ジャーナルElectronics and Communications in Japan (Part II: Electronics)
72
10
DOI
出版ステータスPublished - 1989

ASJC Scopus subject areas

  • Physics and Astronomy(all)
  • Computer Networks and Communications
  • Electrical and Electronic Engineering

フィンガープリント 「Fabrication of a micropump for integrated chemical analyzing systems」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル