Estimation of Tribological Characteristics of Electrolyzed Oxide Layers on ELID-Grinding Wheel Surfaces

T. Kato, N. Itoh, H. Ohmori, K. Katahira, W. Lin, K. Hokkirigawa

研究成果: Article

5 被引用数 (Scopus)

抄録

The purpose of this work is to investigate tribological characteristics of electrolyzed oxide layers on ELID-grinding wheel surfaces under dry and lubricated conditions. A pin on disk type wear apparatus is used with reciprocating lower disk specimen. Two kinds of carbon bond materials CR and CRB, and cast iron bonded materials SD are used for the disk specimen. The normal load is changed from 0.49 N to 4.9 N. It was found that when two kinds of carbon resin bonded materials are used for disk specimen, friction coefficient of electrolyzed layers has a higher value than that of without electrolyzed layer. Specific wear rate of CR with electrolyzed layer is from 2 to 11 times of the one without electrolyzed layer. Specific wear rate of CRB with electrolyzed layer is from 10 to 128 times of the one without electrolyzed layer. Specific wear rate of SD with electrolyzed layer is from 45 to 461 times of the one without electrolyzed layer.

本文言語English
ページ(範囲)257-262
ページ数6
ジャーナルKey Engineering Materials
257-258
出版ステータスPublished - 2004 1 1

ASJC Scopus subject areas

  • Materials Science(all)
  • Mechanics of Materials
  • Mechanical Engineering

フィンガープリント 「Estimation of Tribological Characteristics of Electrolyzed Oxide Layers on ELID-Grinding Wheel Surfaces」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル