EM radiation through aperture of metallic enclosure with a PCB inside

Shogo Miyata, Yoshiki Kayano, Hiroshi Inoue

    研究成果: Conference contribution

    3 被引用数 (Scopus)

    抄録

    Enclosure technique is widely used to control electromagnetic (EM) radiation from electronic devices. As the aperture of the enclosure causes leakage of EM wave, desired shielding effectiveness (SE) may not be satisfied. In this paper, as a basic study to establish EMC guideline for shielding enclosure with practical PCBs (Printed Circuit Boards), influence on EM radiation through aperture of metallic enclosure with a PCB inside was investigated. A typical metallic enclosure, 300×200×100 mm 3, with an aperture, 200×32 mm2 and PCB of 230×55 mm2 are used to experiment and calculation. The PCB is put in the enclosure and the placement of the PCB, angle of the PCB α, are changed. Firstly, angle-pattern and frequency responses of far-electric fields were discussed. It was demonstrated that PCB placement influences resonance and strength of the EM radiation from aperture of the enclosure. Horizontal and vertical component of EM radiation is the smallest in five test placements at the "α =270 degrees" case in which signal trace is turned opposite side of aperture. Secondly, frequency response of SE, which defined as the ratio of EM field level of "PCB only" case, which means without enclosure, to "PCB in enclosure" case, is discussed. The α =270 case has the largest SE. Finally, the electric field distribution was also discussed by calculation to understand the details of the effect of PCB placement. It was demonstrated that electric-coupling between PCB and wall of aperture side in the α =270 case is weakened. This study is the basic but new considerations to realize method for suppressing EM radiation from a PCB with practical engineering stand point.

    本文言語English
    ホスト出版物のタイトル2008 Asia-Pacific Symposium on Electromagnetic Compatibility and 19th International Zurich Symposium on Electromagnetic Compatibility, APEMC 2008
    ページ658-661
    ページ数4
    DOI
    出版ステータスPublished - 2008 9月 19
    イベント2008 Asia-Pacific Symposium on Electromagnetic Compatibility and 19th International Zurich Symposium on Electromagnetic Compatibility, APEMC 2008 - Suntec
    継続期間: 2008 5月 192008 5月 23

    Other

    Other2008 Asia-Pacific Symposium on Electromagnetic Compatibility and 19th International Zurich Symposium on Electromagnetic Compatibility, APEMC 2008
    CitySuntec
    Period08/5/1908/5/23

    ASJC Scopus subject areas

    • 電子工学および電気工学

    フィンガープリント

    「EM radiation through aperture of metallic enclosure with a PCB inside」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル