Effects of post-processing on cyclic fatigue response of a titanium alloy additively manufactured by electron beam melting

Xiaoli Shui, Kenta Yamanaka, Manami Mori, Yoshihiko Nagata, Kenya Kurita, Akihiko Chiba

研究成果: Article査読

46 被引用数 (Scopus)

抄録

To establish the benefits of electron beam melting (EBM) for the fabrication of Ti–6Al–4V alloy components, it is necessary to properly understand the fatigue performance of the alloy. In the present study, we investigated the high-cycle fatigue behaviors of EBM-fabricated Ti–6Al–4V alloy component samples and systematically assessed their correlation with the microstructure, porosity, and (quasistatic) tensile properties of the material. The associated texture evolution and elemental distributions of the components were also examined. The employed samples were post-processed by hot isostatic pressing (HIP) and heat treatment (HT) at 920 °C for 2 h with and without the application of 100-MPa gas pressure, respectively. The as-built samples consisted of fine acicular α (hcp) microstructures, attributable to the β (bcc) → α' (hcp) martensitic transformation during the EBM process, and these microstructures were coarsened by the HIP and HT processes. However, the fatigue properties of the HIP samples were found to be superior to those of the other samples despite the coarsened microstructure and reduced tensile strength. Notably, a small amount of porosity was observed in the as-built and HT samples, although all the samples were almost fully dense, having relative densities of ~100%. The pores were found to act as crack initiation sites, with the defects having a greater effect on the fatigue properties of the samples than the microstructures. Optimization of the parameters of both the EBM process and the raw powder production process is required to enhance the performance of EBM-fabricated Ti–6Al–4V alloy components.

本文言語English
ページ(範囲)239-248
ページ数10
ジャーナルMaterials Science and Engineering A
680
DOI
出版ステータスPublished - 2017 1 5

ASJC Scopus subject areas

  • Materials Science(all)
  • Condensed Matter Physics
  • Mechanics of Materials
  • Mechanical Engineering

フィンガープリント 「Effects of post-processing on cyclic fatigue response of a titanium alloy additively manufactured by electron beam melting」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル