Effect of slag composition on the dissolution of phosphorus from steelmaking slag by selective leaching

Chuan Ming Du, Xu Gao, Shigeru Ueda, Shin Ya Kitamura

研究成果: Article査読

5 被引用数 (Scopus)

抄録

Steelmaking slag is considered a potential source of P because of its huge production. In steelmaking slag, P is mainly distributed in the C2S-C3P solid solution which is more water-soluble than other phases. In order to recover P and recycle steelmaking slag, we have proposed the selective leaching of the P-concentrated solid solution. To clarify the applicability of this process to steelmaking slags with various compositions, the effects of P2O5 content, Fe2O3 content, and slag basicity on the dissolution behavior of the slag modified with the addition of Na2O were investigated in this study. It was determined that the dissolution ratio of P reached approximately 76% regardless of the P2O5 content in slag, while the dissolution of Fe and Mg was poor. In the case of high P2O5 content, a leachate with higher P concentration and lower Ca and Si concentrations was obtained, exhibiting excellent selective leaching of P. Increasing the Fe2O3 content in slag not only promoted the dissolution of P but also decreased the dissolution ratios of other elements. With the increase in slag basicity, the dissolution ratios of Ca, Si, and P all increased. Most of the solid solution was dissolved from each slag without a large dissolution of other phases at pH 6, indicating that selective leaching of the solid solution was achieved over a wide range of slag compositions. After leaching, a residue with low P2O5 content and high Fe2O3 content was obtained.

本文言語English
ページ(範囲)1659-1668
ページ数10
ジャーナルIsij International
58
9
DOI
出版ステータスPublished - 2018 9 15

ASJC Scopus subject areas

  • 材料力学
  • 機械工学
  • 金属および合金
  • 材料化学

フィンガープリント

「Effect of slag composition on the dissolution of phosphorus from steelmaking slag by selective leaching」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル