Distribution of P2O5 between solid dicalcium silicate and liquid phases in CaO-SiO2-Fe2O3 system

Ken Ichi Shimauchi, Shin Ya Kitamura, Hiroyuki Shibata

研究成果: Article査読

89 被引用数 (Scopus)

抄録

In most cases, the slag used in hot metal dephosphorization is saturated with dicalcium silicate (C2S) and contains two phases solid C 2S and liquid. It is known that C2S and tricalcium phosphate (C3P) form a solid solution over a wide range of composition. The distribution ratio of P2O5 between the solid solution and the liquid slag phase has been reported to be very high. In order to determine the maximum possible concentration of P2O 5 in the solid solution, the distribution ratio of P 2O5 in slag containing a high concentration of P 2O5 was measured in this study, and the influence of MgO and MnO on the distribution ratio was also investigated. CaO-SiO 2-Fe2O3 slag containing up to 18% P 2O5 was melted at 1 873 K and then cooled to 1 673 K at a rate of 10 K/min. During cooling, the solid solution of C2S and C3P precipitated from the liquid slag. A linear relationship, which was independent of the lime/silica ratio and P2O5 content, was found to exist between the distribution ratio of P2O5 and the T .Fe content. On the contrary, the concentration of P 2O5 in the solid solution was strongly influenced by the lime/silica ratio and P2O5 content. If the P 2O5 content was high enough and the T.Fe content was controlled to show the high distribution ratio, the concentration of C 3P in the solid solution can be increased to 100%. No significant change was observed in the distribution ratio upon the addition of MgO and MnO.

本文言語English
ページ(範囲)505-511
ページ数7
ジャーナルIsij International
49
4
DOI
出版ステータスPublished - 2009

ASJC Scopus subject areas

  • 材料力学
  • 機械工学
  • 金属および合金
  • 材料化学

フィンガープリント

「Distribution of P<sub>2</sub>O<sub>5</sub> between solid dicalcium silicate and liquid phases in CaO-SiO<sub>2</sub>-Fe<sub>2</sub>O<sub>3</sub> system」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル