Development of an ultra-high speed cutting wheel

S. Yamazaki, K. Syoji, T. Kuriyagawa, Y. Ogura, T. Fukunishi, M. Miyake

研究成果: Article査読

5 被引用数 (Scopus)

抄録

This study examines the development of a cutting wheel that performs ultra-high speed cutting typically at a wheel peripheral speed of 400 m/s. Using FEM, we found that a good material for the wheel core and flange is a titanium alloy or CFRP. Based on these results, we considered the following two methods of manufacturing a cutting wheel: (1) Sintering metal-bonded grindstone and a titanium alloy core. (2) Curing resinoid-bonded grindstone and a CFRP core. In this study, we manufactured a wheel using method (1). The resulting metal-bonded wheel using a titanium alloy core was a success in a rotation test, at a wheel peripheral speed of 450 m/s. This paper describes the manufacturing method, as well as the results of a stress analysis using FEM and the results of the rotation test.

本文言語English
ページ(範囲)271-276
ページ数6
ジャーナルKey Engineering Materials
238-239
DOI
出版ステータスPublished - 2003

ASJC Scopus subject areas

  • Materials Science(all)
  • Mechanics of Materials
  • Mechanical Engineering

フィンガープリント 「Development of an ultra-high speed cutting wheel」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル