Design and analysis of a pneumatic high-impact force drive mechanism for in-pipe inspection robots

研究成果: Article

3 引用 (Scopus)

抜粋

A pneumatic actuator is suitable and safe for in-pipe inspection robots in inflammable circumstances because of its ability to withstand explosions. However, ordinary pneumatic actuators limit driving speed because of their slow response. In this paper, we propose a novel pneumatic drive mechanism that can produce a high-impact force to move the in-pipe robot forward with sufficient speed by a catastrophic phenomenon using rapid release between a magnet and springs. We also introduce an anisotropic friction mechanism that uses a self-locking phenomenon to transmit the impact force to the pipe walls efficiently. A pin retraction mechanism that releases the self-locking condition is applied to retrieve the robot from the pipes. Optimizations of the proposed design were conducted based on a motion simulation model and verified in experiments. The experimental results obtained for maximum driving speeds in a straight pipe with different material types were approximately 90 and 50 mm/s for horizontal and vertical pipes, respectively. Stable strokes were also observed at different driving frequencies from 0.5 to 2.0 Hz.

元の言語English
ページ(範囲)1260-1272
ページ数13
ジャーナルAdvanced Robotics
30
発行部数19
DOI
出版物ステータスPublished - 2016 10 1

ASJC Scopus subject areas

  • Software
  • Control and Systems Engineering
  • Human-Computer Interaction
  • Hardware and Architecture
  • Computer Science Applications

フィンガープリント Design and analysis of a pneumatic high-impact force drive mechanism for in-pipe inspection robots' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用