Contribution in optimization of Zn Cold-sprayed coating dedicated to corrosion applications

E. Lapushkina, S. Yuan, N. Mary, J. Adrien, K. Ogawa, B. Normand

研究成果: Article査読

抄録

Cold spray coatings elaboration requires optimization of numerous parameters in order to reach the best coatings' performances. A systematic approach can be avoided by using an experimental design. A Doehlert uniform shell design was applied in this work to Zn cold sprayed coating. Coatings were produced on steel substrates to provide high corrosion resistant layers. N2 temperature and gas pressures varied from 200 °C to 320 °C and from 2.0 MPa to 3.0 MPa, respectively. Performance maps were plotted for two descriptors: (i) the interfacial porosity volume (substrate coating interface defects), (ii) coating thickness (i.e., coating durability), and validated with the polarization resistance (i.e., corrosion resistance). Results reported three set of optimized temperature and gas pressure values according to the descriptor. Two optimized protection modes can be obtained: a sacrificial mode from heterogeneities in the coating (290 °C and 3.0 MPa), and a barrier protection mode from homogeneous and dense coatings (320 °C and 2.5 MPa). Mechanism of corrosion has been investigated.

本文言語English
論文番号126193
ジャーナルSurface and Coatings Technology
400
DOI
出版ステータスPublished - 2020 10 25

ASJC Scopus subject areas

  • Chemistry(all)
  • Condensed Matter Physics
  • Surfaces and Interfaces
  • Surfaces, Coatings and Films
  • Materials Chemistry

フィンガープリント 「Contribution in optimization of Zn Cold-sprayed coating dedicated to corrosion applications」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル