An Experimental Study on New Ag Coated Fabrics as Shielding Material for Electromagnetic Radiation from PCB

Motoshi Tanaka, Hisashi Takita, Hiroshi Inoue, Yusuke Maeda, Mitsuhiro Umehara, Makoto Tsunashima

    研究成果: Article査読

    抄録

    As a new material, silver (Ag) coated fabric has been developed, and its use for shielding electromagnetic radiation is expected. In this paper, seven kinds of Ag coated fabrics, woven, knitted and nonwoven by Ag coated fibers, are prepared, and placed over a PCB with a microstrip line, which is used as a noise source. By measuring the input impedance of the microstrip line, the distance between the PCB and the fabric is fixed to 8mm to reduce the coupling paths. The shielding effect SE of those fabrics was compared by measuring the magnetic near-field with a small shielded-loop probe. In the results, the resonance frequency is dependent on the fabric's length, as well as the case of a copper sheet. Comparing the texture, the SE of woven and nonwoven fabrics is larger than the knitted fabric. Comparing with the copper sheet, the SE of the fabrics is smaller below 200 MHz, but elsewhere is almost the same.

    本文言語English
    ページ(範囲)988-994
    ページ数7
    ジャーナルIEICE Transactions on Electronics
    E86-C
    6
    出版ステータスPublished - 2003 6

    ASJC Scopus subject areas

    • 電子材料、光学材料、および磁性材料
    • 電子工学および電気工学

    フィンガープリント

    「An Experimental Study on New Ag Coated Fabrics as Shielding Material for Electromagnetic Radiation from PCB」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル