Stochastic counting MEMS sensor using white noise oscillation for high temperature environment

Yohei Hatakeyama, Masayoshi Esashi, Shuji Tanaka

Research output: Contribution to journalArticlepeer-review

1 Citation (Scopus)

Abstract

This paper describes a stochastic counting MEMS sensor, which will be used in low S/N environments like in high temperature plants. A mass which vibrates between two counter electrodes by white voltage noise is "pulled-in" to either of the electrodes by the application of pulse voltage to the mass. The direction of the pull-in is determined stochastically, and the probability that the mass is pulled-in to a particular side depends on mechanical strain applied to the sensor structure. This sensing principle was confirmed by simulation, and then the sensor was prototyped using an SOI wafer. The probability of pull-in to a particular side was tuned by bias voltage applied to the counter electrodes, as predicted by the simulation. When the frequency of the pulse voltage for pull-in increases, the behavior of the sensor becomes unintended, because the mass is pulled-in during dumping vibration after releasing from the previous pull-in. This limits the sensing speed, but strain sensing is possible just counting the number of pull-in to a particular side, which is easy even in low S/N environments.

Original languageEnglish
Pages (from-to)178-184
Number of pages7
JournalIEEJ Transactions on Sensors and Micromachines
Volume131
Issue number5
DOIs
Publication statusPublished - 2011

Keywords

  • Pull-in
  • Stochastic sensor
  • Strain sensing
  • White noise

ASJC Scopus subject areas

  • Mechanical Engineering
  • Electrical and Electronic Engineering

Fingerprint

Dive into the research topics of 'Stochastic counting MEMS sensor using white noise oscillation for high temperature environment'. Together they form a unique fingerprint.

Cite this