Relationship between the liquidus surface and structures of Zr-Cu-Al bulk amorphous alloys

Yoshihiko Yokoyama, Hiroshi Inoue, Kenzo Fukaura, Akihisa Inoue

Research output: Contribution to journalArticlepeer-review

58 Citations (Scopus)

Abstract

By using a Al2O3 cell coated with Si3N4, the melting point (Tm) of the cast bulk amorphous samples were measured on DTA curves cooled from the molten state. Based on the Tm data, the partial liquidus surface of Zr-Cu-Al ternary alloys was determined. A ternary eutectic point is located around Zr50Cu40Al10, and low melting temperatures of less than 1273 K were obtained in a wide compositional area of 40-70 at%Zr, 30-60 at% Cu and 0-10 at%Al. Bulk amorphous alloys in Zr-Cu-Al ternary system were produced by an arc-casting method and the highest tensile strength of 200 MPa was observed in Zr50Cu40Al10.

Original languageEnglish
Pages (from-to)575-579
Number of pages5
JournalMaterials Transactions
Volume43
Issue number3
DOIs
Publication statusPublished - 2002 Mar

Keywords

  • Bulk amorphous alloy
  • Isothermal section
  • Liquidus surface
  • Mechanical properties
  • Ternary eutectic point
  • Zirconium-copper-aluminum alloy system

ASJC Scopus subject areas

  • Materials Science(all)
  • Condensed Matter Physics
  • Mechanics of Materials
  • Mechanical Engineering

Fingerprint Dive into the research topics of 'Relationship between the liquidus surface and structures of Zr-Cu-Al bulk amorphous alloys'. Together they form a unique fingerprint.

Cite this