Fabrication of anisotropic NdFeB powders by Ta sputtering

Research output: Contribution to journalArticle

Abstract

The influence of Ta sputtering on the fabrication of anisotropic NdFeB powders was investigated. X-ray fluorescence and secondary electron microscopy analysis revealed that the measured Ta content after sputtering was 5.6 mass% and the Ta particles were located on the surfaces of the NdFeB grains. Ta coating on NdFeB grain could prevent necking between NdFeB grains after annealing at 700°C for NdFeB powders with and without Ta sputtering, and the Ta-sputtered powder could be easily crushed. After crushing and sieving under 75 µm, the coercivity value of the powders with and without Ta sputtering were almost the same, while the anisotropy of Ta-sputtered powder was higher. Upon annealing and crushing, the degree of texture (), which is used to evaluate anisotropy, improved from 0.08 to 0.73 for the Ta-sputtered NdFeB powder and was higher than that for the non-Ta-sputtered NdFeB powder. The results demonstrate that Ta sputtering can be an effective technique for the fabrication of anisotropic NdFeB powders.

Original languageEnglish
Pages (from-to)830-836
Number of pages7
JournalMaterials Transactions
Volume60
Issue number5
DOIs
Publication statusPublished - 2019 Jan 1

Keywords

  • Bonded magnet
  • NdFeB powder
  • Sputtering
  • Ta

ASJC Scopus subject areas

  • Materials Science(all)
  • Condensed Matter Physics
  • Mechanics of Materials
  • Mechanical Engineering

Fingerprint Dive into the research topics of 'Fabrication of anisotropic NdFeB powders by Ta sputtering'. Together they form a unique fingerprint.

  • Cite this