Erratum to “Determination of ɑ/β phase boundaries and mechanical characterization of Mg-Sc binary alloys” [Mater. Sci. Eng. A 670 (2016) 335–341]

Research output: Contribution to journalComment/debatepeer-review

Abstract

The publisher regrets that some of the Author's requested amendments were not applied. These were as follows: • On page 135, Introduction, the sentence in the second column should read as follows: Meanwhile, there are a few reports on mechanical properties of Sc-added Mg alloys with single α phase [11–13]. Very recently, the present authors have found that Mg-Sc alloy with a β phase shows significant age hardening due to the formation of very fine α precipitates in β matrix [14].• On page 136, Section 2, the sentence should read as follows: The obtained diffusion couples were annealed at 773, 823 and 873 K for 96, 72 and 72 h, respectively, in an Ar atmosphere.• On page 136, Section 2, the sentence should read as follows: The Mg-20 at% Sc alloy ingot melted in a high frequency induction furnace was hot rolled at 873 K and then cold rolled until a thickness of about 0.7 mm with annealing at 873 K.• Table 1 show appears as follows: • Page 340, Section 3.3, the sentence should read as follows: Therefore, the specific strength is also higher than the conventional high strength alloys, such as AZ91, ZK60, etc. [10].The publisher would like to apologise for any inconvenience caused.

Original languageEnglish
Pages (from-to)713
Number of pages1
JournalMaterials Science and Engineering A
Volume674
DOIs
Publication statusPublished - 2016 Sep 30

ASJC Scopus subject areas

  • Materials Science(all)
  • Condensed Matter Physics
  • Mechanics of Materials
  • Mechanical Engineering

Fingerprint

Dive into the research topics of 'Erratum to “Determination of ɑ/β phase boundaries and mechanical characterization of Mg-Sc binary alloys” [Mater. Sci. Eng. A 670 (2016) 335–341]'. Together they form a unique fingerprint.

Cite this