Development on stress monitoring method for measurement of cyclic stress of railway axles

Seok Jin Kwon, Kazuhiro Ogawa, Tetsuo Shoji

Research output: Contribution to journalArticle

Abstract

In general, the S-N curve in railway axles was mainly carried out under 107-108 cycles, while the service area of a railway axle is 108-109 cycles. The strain gages using electrical resistance have been used to measure stresses in railway vehicle wheelsets. However, there are some problems with strain gages using electrical resistance for railway axles. For example, the measured data is for special or limited intervals only. Strain gage installation is complicated, that is, it requires lead wires for measurement. The design of railway axles makes use of data that was obtained many years ago. The applied stresses in wheelsets running for a long time and in new railway vehicle wheelsets have not been studied clearly yet. It is necessary to carry out stress monitoring for more than 108 cycles to evaluate the safety of railway wheelset. Therefore, it is necessary to develop new stress monitoring techniques that can easily measure the working stress of the wheelset. In the present paper, the stress measurement technique of copper electroplating is considered because of its high potential for this purpose.

Original languageEnglish
Pages (from-to)84-89
Number of pages6
JournalKey Engineering Materials
Volume297-300 I
DOIs
Publication statusPublished - 2005 Jan 1

Keywords

  • Copper electroplating
  • Cyclic stress
  • Focused ion beam
  • Railway axle
  • S-N curve
  • Slit
  • Stress monitoring method

ASJC Scopus subject areas

  • Materials Science(all)
  • Mechanics of Materials
  • Mechanical Engineering

Fingerprint Dive into the research topics of 'Development on stress monitoring method for measurement of cyclic stress of railway axles'. Together they form a unique fingerprint.

Cite this