Control of dislocation configuration in sapphire

Atsutomo Nakamura, K. P.D. Lagerlöf, Katsuyuki Matsunaga, Jun Tohma, Takahisa Yamamoto, Yuichi Ikuhara

    Research output: Contribution to journalArticlepeer-review

    26 Citations (Scopus)


    A method to introduce high density of unidirectional dislocations in sapphire by a "two-stage deformation" technique and a heat-treatment of thin plate is proposed. After deformation of sapphire crystals by basal slip at 1400°C, the samples were further deformed at 1200°C as a second stage. It was found that twinning and cracking normally observed during deformation tests at 1200°C were not observed in the crystals deformed using the two-stage deformation technique, and dislocation densities as high as 1.1 × 109/cm2 were obtained. This is because the glide dislocations generated at 1400°C promoted slip over twinning in the additional deformation at 1200°C. Subsequently, thin plates containing the high density of dislocations were annealed at 1400°C for 30 min. As a result, it was found that dislocations in the thin plate were able to be straightened across its two opposite surfaces. This is believed to be due to the large image forces acting on the dislocations due to the free surface.

    Original languageEnglish
    Pages (from-to)455-462
    Number of pages8
    JournalActa Materialia
    Issue number2
    Publication statusPublished - 2005 Jan 10


    • Dislocations
    • High temperature deformation
    • Transmission electron microscopy
    • Twinning
    • α-AlO single crystal (sapphire)

    ASJC Scopus subject areas

    • Electronic, Optical and Magnetic Materials
    • Ceramics and Composites
    • Polymers and Plastics
    • Metals and Alloys


    Dive into the research topics of 'Control of dislocation configuration in sapphire'. Together they form a unique fingerprint.

    Cite this